LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Front Drive Axle/Differential -- F250-F550 Super Duty) >> In-Vehicle Repair >> Axle Shaft Seal >> Installation

Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new knuckle seal onto the axle shaft.
    1. Position the knuckle seal onto the axle shaft.
    2. Using the Driver and Knuckle Seal Installer and a soft-faced hammer, seat the knuckle seal onto the axle shaft.
    Fig 1: Installing Main Seal Onto Axle Shaft
    G06776400Courtesy of FORD MOTOR CO.
  2. Position the axle shaft into the shaft housing.
  3. Using the Driver and Knuckle Seal Installer with a soft-faced hammer, install the knuckle seal into the wheel knuckle.
    Fig 2: Installing Main Seal Into Wheel Knuckle
    G06777416Courtesy of FORD MOTOR CO.
  4. Install the wheel bearing and hub assemblies. For additional information, refer to FRONT SUSPENSION - FOUR WHEEL DRIVE (4WD) .
scientia non olet · About LEMON Manuals