Electronic Throttle Actuator Control (TAC)

WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 2014 Lincoln Navigator, 2014 Lincoln MKZ, 2014 Lincoln MKX, 2014 Lincoln MKT, and 2014 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

The electronic TAC is a DC motor controlled by the PCM. There are 2 designs for the electronic TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. Both designs use an internal spring to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. For additional information, refer to TORQUE BASED ELECTRONIC THROTTLE CONTROL (ETC) .

Fig 1: Identifying Electronic Inline Throttle Actuator Control

Courtesy of FORD MOTOR CO.

Fig 2: Identifying Parallel Electronic Throttle Actuator Control Design

Courtesy of FORD MOTOR CO.