LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Rear Drive Axle/Differential - Ford 10.50-Inch Ring Gear -- F250-F350 Super Duty) >> In-Vehicle Repair >> Electronic Locking Differential (ELD) Field Coil >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier. For additional information, refer to Differential Case .
  2. Remove the LH differential carrier bearing. For additional information, refer to Differential Bearings .
  3. Remove the ELD retaining ring and washer.
    Fig 1: Identifying ELD Retaining Ring And Washer
    G07478634Courtesy of FORD MOTOR CO.
  4. Remove the ELD coil.
    Fig 2: Removing ELD Coil
    G07478635Courtesy of FORD MOTOR CO.
  5. Remove the thrust bearing and thrust plate.
    Fig 3: Identifying Thrust Bearing And Thrust Plate
    G07478636Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals