Test Procedure

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

AU1 PRELIMINARY DIAGNOSIS

NOTE: Diagnose and repair all circuit DTCs before diagnosing range or performance DTCs.

Is DTC P0069 present?

Yes	No
GO to AU2.	GO to DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONS .

AU2 COMPARE THE KEY ON ENGINE OFF (KOEO) BARO AND MAP PID VALUES

Ignition ON, engine OFF.
Access the PCM and monitor the BARO (PRESS) and MAP_A (PRESS) PIDs.

Is the MAP sensor reading within 4.5 kPa (0.65 psi) of the BARO reading?

Yes	No
REMOVE and CHECK the MAP sensor for moisture, ice or any other type of restriction. If necessary, INSTALL a new MAP sensor. REFER to the appropriate Electronic Engine Controls article. Clear the PCM DTCs. REPEAT the self-test. If the concern or DTC is still present, GO to AU3.	INSTALL a new MAP sensor. REFER to the appropriate Electronic Engine Controls article. Clear the PCM DTCs. REPEAT the self-test.

AU3 CHECK FOR CORRECT PCM OPERATION

Disconnect all the PCM connectors.
Visually inspect for:
- pushed out pins
- corrosion
Connect all the PCM connectors and make sure they seat correctly.
Carry out the PCM self-test.
Verify the concern is still present.

Is the concern still present?

Yes	No
INSTALL a new PCM. REFER to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .	The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.