Applique - Front, Roof: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.

WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.

NOTE: The front roof applique will be damaged during the removal procedure. Install a new front roof applique.

Remove the roof glass panel. For additional information, refer to GLASS, FRAMES AND MECHANISMS .
Using a suitable prying tool, pry up on the corner of the applique to gain access to the urethane adhesive.

Fig 1: Removing Roof Glass Panel
Courtesy of FORD MOTOR CO.
NOTE: Lubricate the urethane adhesive with water to aid the Deluxe Windshield Removal Tool when cutting the urethane adhesive.

Using the Deluxe Windshield Removal Tool, begin cutting from either end towards the middle of the car. For additional information on the urethane adhesive path, refer to the illustration.

Fig 2: Identifying Urethane Adhesive Applying Pattern On Roof Glass Applique
Courtesy of FORD MOTOR CO.
Rotate the applique up and forward while moving toward the interior of the car. Bend the applique as necessary to gain access to the adhesive.
Remove the applique and discard.