LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Four Wheel Drive (4WD) Systems -- F250-F550 Super Duty) >> Diagnosis And Testing >> Electronic Locking Differential (ELD) System >> Pinpoint Tests >> Pinpoint Test Q: DTC P1833:00 and P1835:00 >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

When the Mode Select Switch (MSS) is engaged to lock the rear differential, a Pulse Width Modulated (PWM) signal is sent to the Electronic Locking Differential (ELD) field coil by the Transfer Case Control Module (TCCM) through the differential lock control circuit. This signal is a PWM signal which is initially 98% duty cycle to lock the differential and decreases to 40% duty cycle once the differential is locked. If the differential lock control circuit is open or shorted to ground, the TCCM senses a signal is not reaching the differential and sets a DTC.

This pinpoint test is intended to diagnose the following: