LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 470 (Engine Cooling System) >> Removal And Installation >> Coolant Pump - 5.8L (4V) >> Coolant Pump and Pulley >> Installation

Coolant Pump and Pulley: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
    • Install a new coolant pump O-ring seal and lubricate with clean engine coolant.
  2. Fill and bleed the cooling system. Refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  3. Fill and bleed the SC cooling system. Refer to SUPERCHARGER COOLING .
scientia non olet · About LEMON Manuals