Removal and Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Remove the block heater cover.
-
NOTE: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or the wiring may be damaged.
Disconnect the block heater electrical connector.
- Remove the block heater.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .