Valve Cover - RH (View 2 of 2): Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: Installation of new seals is only required if damaged seals were removed.
Using the VCT Spark Plug Tube Seal Installer and Handle, install new spark plug tube seals.
-
NOTE: Installation of new seals is only required if damaged seals were removed.
Using the Differential Bearing Cone Installer and Handle, install new VCT solenoid seal(s).
-
NOTE: Failure to use the correct Motorcraft® High Performance Engine RTV Silicone may cause the engine oil to foam excessively and result in serious engine damage.NOTE: If the valve cover is not installed and the fasteners tightened within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone gasket remover and metal surface prep. Failure to follow this procedure can cause future oil leakage.
Apply an 8 mm (0.31 in) bead of Motorcraft® High Performance Engine RTV Silicone to the engine front cover-to-RH cylinder head joints.
- Using a new gasket, install the RH valve cover and tighten the 3 bolts and 8 stud bolts in the sequence shown in illustration.
- Tighten to 10 Nm (89 lb-in).
- Ensure the VCT seals in the valve cover are below the top of the VCT oil control solenoid electrical connector or the VCT seal may leak oil.
- Attach the heater tube retainer to the RH valve cover stud bolt.
- Install the heater tube bolt.
- Tighten to 23 Nm (17 lb-ft).
- Attach all of the wiring harness retainers to the RH valve cover and stud bolts.
- Connect the 2 RH VCT solenoid electrical connectors.
- Connect the PCV tube quick connect coupling to the RH valve cover. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION .
- Install the RH ignition coils. For additional information, refer to ENGINE IGNITION - 3.7L .