LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (Interior Trim And Ornamentation) >> Removal And Installation >> Quarter Window Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: On the coupe, install the front locating hook, then snap the A-pillar trim panel in place, working rearward.

    Remove the 2 A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL .

  2. Remove the rear quarter trim panel. For additional information, refer to QUARTER TRIM PANEL - COUPE .
  3. Open the garment hook cover. Remove the bolt and garment hook.
  4. Remove the upper front safety belt anchor bolt cover and bolt.
    • To install, tighten to 48 Nm (35 lb-ft).
  5. Remove the quarter window trim panel, by pulling outward.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals