LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (Interior Trim And Ornamentation) >> Removal And Installation >> Quarter Trim Panel - Convertible >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door scuff plate. For additional information, refer to SCUFF PLATE TRIM PANEL .
  2. NOTE: To avoid damage to the upper quarter trim panel cap, remove any retaining clips from the body and attach them to the upper quarter trim panel cap before installing.
    NOTE: Remove and discard the upper quarter trim panel cap 2-stage high-retention retaining clip.

    Remove the upper quarter trim panel cap by lifting upward to release the first stage of the upper quarter trim panel cap 2-stage high retention retaining clip and the secondary retaining clip. Using suitable pliers, release the second stage of the 2-stage high-retention retaining clip and remove the upper quarter trim panel cap.

  3. Remove the rear seat cushion. For additional information, refer to SEATING .
  4. NOTE: To avoid damage to the quarter trim panel, remove any retaining clips from the body and attach them to the quarter trim panel.
    NOTE: This procedure must be performed with the roof up, in order to access the rear pushpins.

    Remove the upper quarter trim panel, pushpin retainer and quarter trim panel.

  5. NOTE: To avoid damage to the quarter trim panel, remove any retaining clips from the body and attach them to the quarter trim panel.

    Remove the 2 pushpin retainers and the lower quarter trim panel.

  6. To install, reverse the removal procedure.
    • Install a new upper quarter trim panel cap 2-stage high-retention retaining clip.
scientia non olet · About LEMON Manuals