LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (Interior Trim And Ornamentation) >> Removal And Installation >> A-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sun visor bracket cover.
  2. Remove the 2 sun visor screws and set the sun visor aside.
  3. Pull outward on the A-pillar trim to release the retaining clip and the pushpin from the body.
  4. Pull slightly down and straight back on the A-pillar to unhook the front lower portions of the A-pillar trim panel.
  5. NOTE: To avoid any damage to the A-pillar trim panel, remove any clips from the body and attach them to the A-pillar trim panel.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals