LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Door Lock Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the door window glass to the full-up position.
  2. Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Position the water shield aside.
  4. Remove the bolt and turn the door lock cylinder clockwise one-eighth of a turn.
    • To install, tighten to 9 Nm (80 lb-in).
  5. Disconnect the door lock cylinder actuating rod and remove the door lock cylinder.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals