LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Caliper Support Bracket >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear axle shaft. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 8.8-INCH RING GEAR
  2. Remove the 3 bolts and the brake disc shield.
    • To install, tighten to 20 Nm (177 lb-in).
  3. NOTE: Make sure the anti-moan bracket holes, the brake caliper support bracket and the brake caliper anchor plate holes line up during installation.

    If equipped, remove the anti-moan bracket.

    • To install, tighten to 35 Nm (26 lb-ft).
  4. Remove the 4 brake caliper support bracket nuts, bolts and the bracket.
    • To install, tighten to 68 Nm (50 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals