LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Installation

Rear Brake Caliper Anchor Plate: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: In order for the brake caliper anchor plate bolts to attain the proper clamp load when installed, the residual threadlock compound must be cleaned out of the bolt threads of the anchor plate.

    Use the specified brake parts cleaner to clean any residual threadlock compound, and any other foreign material, from the threads of the brake caliper anchor plate.

  2. Position the brake caliper anchor plate and install 2 new anchor plate bolts.
    • Tighten to 103 Nm (76 lb-ft).
  3. Install the brake pads. For additional information, refer to BRAKE PADS .
scientia non olet · About LEMON Manuals