Differential Carrier: Removal

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Remove the axle shafts. For additional information, refer to AXLE SHAFT .
NOTE: Index-mark the position of the differential bearing caps, as arrows may not be visible. The differential bearing caps must be installed in their original locations and positions.

Remove the 4 differential bearing cap bolts and the 2 differential bearing caps.

Fig 1: Locating Differential Bearing Cap And Bolts
Courtesy of FORD MOTOR CO.
NOTE: Place a wood block between the pry bar and the axle housing to protect the machined surface from damage.

NOTE: Index-mark the position of the differential bearing shims. The differential bearing shims must be installed in their original locations and positions.

Using pry bars and wood blocks, remove the differential carrier assembly from the axle housing.

Fig 2: Removing Differential Carrier Assembly Using Pry Bars And Wood Blocks
Courtesy of FORD MOTOR CO.