LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 442 (Rear Drive Axle/Differential (Ford 8.8")) >> In-Vehicle Repair >> Rear Wheel Bearing and Axle Shaft Seal >> Installation

Rear Wheel Bearing and Axle Shaft Seal: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new rear wheel bearing with the axle lubricant.
  2. Using the Axle Shaft Bearing Installer and Adapter, install the new rear wheel bearing.
    Fig 1: Installing New Rear Wheel Bearing Using Axle Shaft Bearing Installer And Adapter
    G06384503Courtesy of FORD MOTOR CO.
  3. Lubricate the lip of the new axle shaft oil seal with grease.
  4. Using the Rear Axle Oil Seal Installer and Adapter, install the new axle shaft oil seal.
    Fig 2: Installing Axle Shaft Oil Seal Using Rear Axle Oil Seal Installer And Adapter
    G06384504Courtesy of FORD MOTOR CO.
  5. Install the axle shaft. Refer to AXLE SHAFT .
scientia non olet · About LEMON Manuals