LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 442 (Rear Drive Axle/Differential (Ford 8.8")) >> In-Vehicle Repair >> Differential Cooler Lines - Rear >> Installation

Differential Cooler Lines - Rear: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. NOTE: Service refill capacities are determined by filling the axle to a level of 5mm below the bottom of the fill hole with the axle at ride height.

    Remove the axle plug and fill the axle with 1.89-2.01L (4-4.25 pt) of axle lubricant and a additional 4.0 oz of friction modifier additive, then use a scan tool to operate the oil cooler pump and add a additional 1.10L (2 pt) of axle lubricant and a additional 2 oz of friction modifier and install the filler plug.

    • Tighten to 30 Nm (22 lb-ft).
scientia non olet · About LEMON Manuals