Wheel Speed Sensor Ring - Rear: Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Using the Axle Bearing/Seal Plate and the Wheel Speed Sensor Ring Installer, align the rear anti-lock brake sensor indicator to the rear axle shaft.

Fig 1: Aligning Rear Anti-Lock Brake Sensor Indicator To Rear Axle Shaft Using Special Tools
Courtesy of FORD MOTOR CO.
Using the Axle Bearing/Seal Plate and the Wheel Speed Sensor Ring Installer, press the rear anti-lock brake sensor on the rear axle shaft to specification.

Fig 2: Pressing Rear Anti-Lock Brake Sensor On Rear Axle Shaft Using Axle Bearing/Seal Plate And Wheel Speed Sensor Ring Installer
Courtesy of FORD MOTOR CO.
Install the rear axle shaft. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 8.8-INCH RING GEAR .