Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
The VDM sends a current to the damper solenoids based on HS-CAN messages. The VDM continually monitors the damper solenoid circuits and sets a DTC when a circuit fault is detected. A shorted or open damper solenoid also causes the VDM to set a DTC.
DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
|
|
These DTCs set in continuous memory and on-demand when the VDM detects a short to ground on one or both of the damper solenoid circuits for longer than 3 seconds. |
|
|
|
|
|
|
|
|
|
|
|
This DTC sets in continuous memory and on-demand when the VDM detects a short to battery on one or both of the damper solenoid circuits for longer than 3 seconds. |
|
|
|
|
|
|
|
|
|
|
|
This DTC sets in continuous memory and on-demand when the VDM detects an open on one or both of the damper solenoid circuits for longer than 3 seconds. |
|
|
|
|
|
|
|
|