Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
The VDM requires an operating voltage that is between 9 and 16 volts. The VDM receives this voltage from the BCM. The VDM has a single ground circuit located in the engine compartment wiring harness. Excessive resistance or an open in one or more of these circuits, a discharged battery or a inoperative charging system will result in the VDM setting a DTC.
DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
|
Battery Voltage: Circuit Voltage Below Threshold | This DTC sets in continuous memory and on-demand if the voltage supplied to the VDM falls below 9 volts for more than 5 seconds. |