Pinpoint Test Ar: The Turn Signal On Warning Chime Is Inoperative
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- AR1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AR2.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AR2 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- Insert the key into the ignition lock cylinder.
- Open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime work correctly?
- Yes : GO to AR3.
- No : GO to PINPOINT TEST AM .
- AR3 CHECK THE TURN SIGNAL INDICATORS OPERATION
- Ignition ON.
- Verify the turn signal indicators operation.
- Do the turn signal indicators operate correctly?
- Yes : GO to AR4.
- No : GO to PINPOINT TEST Z .
- AR4 CHECK THE ODOMETER FOR CORRECT OPERATION
- Drive the vehicle and observe the odometer for correct operation.
- Does the odometer operate correctly?
- Yes : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation
- No : GO to PINPOINT TEST L .