Pinpoint Test An: The Headlamps On Warning Chime Is Inoperative
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- AN1 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AN2.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AN2 CHECK THE SAFETY BELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the safety belt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
- Does the safety belt warning chime operate for approximately 6 seconds?
- Yes : GO to AN3.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AN3 CHECK THE EXTERIOR LAMPS OPERATION
- Ignition OFF.
- Place the headlamp switch in the PARK position.
- Do the parking lamps operate?
- Yes : GO to AN4.
- No : REFER to EXTERIOR LIGHTING .
- AN4 CHECK THE DOOR AJAR WARNING INDICATOR OPERATION
- Ignition ON.
- Open then close the LH front door while observing the door ajar warning indicator in the IPC message center.
- Does the door ajar warning indicator operate correctly?
- Yes : INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.
- No : GO to PINPOINT TEST T .