Removal and Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the electrical connector and remove the reversing lamp switch.
- To install, tighten to 37 Nm (27 lb-ft) (T5OD transmission).
- To install, tighten to 27 Nm (20 lb-ft) (TR3650 or TR6060 transmission).
- To install, reverse the removal procedure.