LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 434 (Exterior Lighting System) >> Removal And Installation >> Ballast >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the headlamp assembly. For additional information, refer to HEADLAMP ASSEMBLY .
  2. Remove the 4 screws and ballast cover.
  3. Disconnect the electrical connectors and remove the ballast.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals