Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

All idler pulleys

Rotate the Supercharger (SC) belt tensioner clockwise and remove the SC belt from the SC pulley.
Smooth idler pulley
Remove the bolt and the SC belt smooth idler pulley.
- To install, tighten to 25 Nm (18 lb-ft).
Grooved idler pulley
Remove the bolt and the SC belt grooved idler pulley.
- To install, tighten to 25 Nm (18 lb-ft).
Heavy load idler pulley
Loosen the coolant pump pulley bolts.
- To install, tighten to 25 Nm (18 lb-ft).
  
  Fig 1: Locating Coolant Pump Pulley Bolts
  Courtesy of FORD MOTOR CO.
Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.
Remove the bolts and the coolant pump pulley.

Fig 2: Locating Bolts And Coolant Pump Pulley
Courtesy of FORD MOTOR CO.
Remove the bolt and the SC belt heavy load idler pulley.
- To install, tighten to 48 Nm (35 lb-ft).
All idler pulleys
To install, reverse the removal procedure.