LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (MULTIFUNCTION Electronic Modules -- F250-F550 Super Duty) >> Removal And Installation >> Upfitter Relay Box >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upfitter switch assembly. For additional information, refer to UPFITTER SWITCH .
  2. Remove the instrument panel steering column opening cover.
  3. Disconnect the 14A303 harness from the 14401 harness in-line connector.
  4. Remove the ground terminal screw and position the 14A303 harness ground terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  5. Remove the 2 screws and the upfitter relay box and harness assembly.
    • To install, tighten to 4 Nm (35 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals