LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 415 (Manual Transaxle/Transmission - Tr6060) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Output Shaft Speed (OSS) electrical connector.
  3. Remove the OSS sensor bolt, then remove the OSS sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals