Pinpoint Test G: The Speedometer Is Inoperative

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

G1 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST
- Check the recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
- Are any DTCs recorded?
- Yes : REFER to the INTRODUCTION -- GASOLINE MODELS or INTRODUCTION - 6.7L DIESEL ENGINE -- F250-F550 SUPER DUTY PICKUPS , and SERVICE INFORMATION . TEST the system for normal operation.
- No : GO to G2.
G2 CARRY OUT THE SPEEDOMETER ACTIVE COMMAND USING THE SCAN TOOL
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IPC DataLogger.
- Select the IPC speedometer (SPDOMETER) active command. Command the speedometer on and off while monitoring the speedometer.
- Does the speed begin at 0 km/h (0 mph) move to 161 km/h (100 mph) and return to 0 km/h (0 mph)?
- Yes : GO to G3.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
G3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?
- Yes : For DTC U0100:00, GO to PINPOINT TEST BA .
  For all other DTCs, REFER to DTC CHARTS .
- No : INSTALL a new PCM. REFER to ELECTRONIC ENGINE CONTROLS - GASOLINE ENGINES -- F250-F550 SUPER DUTY or ELECTRONIC ENGINE CONTROLS - DIESEL ENGINE -- F250-F550 SUPER DUTY . TEST the system for normal operation.