Pinpoint Test Ax: The Parking Brake Warning Chime Is Inoperative
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- AX1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- With the ignition switch in the OFF position and the key in the ignition lock cylinder, open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
- Yes : GO to AX2.
- No : INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC) . TEST the system for normal operation.
- AX2 CHECK THE BRAKE WARNING INDICATOR OPERATION
- Apply the parking brake.
- Ignition ON.
- Observe the brake warning indicator.
- Does the brake warning indicator turn on?
- Yes : GO to AX3.
- No : GO to PINPOINT TEST O .
- AX3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST
- Check for recorded IPC DTCs from the self-test.
- Are any DTCs recorded?
- Yes
: For DTC U0140:00, GO to PINPOINT TEST BF .
For all other DTCs, REFER to DTC CHART .
- No : GO to AX4.
- AX4 RETRIEVE THE RECORDED DTCs FROM THE BCM SELF-TEST
- Check for recorded BCM DTCs from the self-test.
- Are any DTCs recorded?
- Yes : For correct navigation of the DTC, REFER to MULTIFUNCTION ELECTRONIC MODULES .
- No : INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . TEST the system for normal operation.