LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 405 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Motor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel motor has been removed from the roof opening panel assembly, a new roof opening panel motor has been installed or when a new roof opening panel frame has been installed. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
  1. Remove the C-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. If equipped, remove the 2 headliner garment hooks.
  3. Lower the rear of the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. Disconnect the roof opening panel motor electrical connector.
  5. Remove the 3 roof opening panel motor screws.
    • To install, tighten to 4 Nm (35 lb-in).
  6. Remove the roof opening panel motor.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals