Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the front door electrical connector at the A-pillar.

Fig 1: Locating Front Door Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the 2 door check-to-door bolts.
- To install, tighten to 11 Nm (97 lb-in).
  
  Fig 2: Locating Door Check-To-Door Bolts
  Courtesy of FORD MOTOR CO.
NOTE: To minimize the possibility of cross threading, hand-start all fasteners during installation.

NOTE: To avoid damaging the door, this step requires an assistant.

Remove the hinge-to-door bolts.
- To install, tighten to 30 Nm (22 lb-ft).
  
  Fig 3: Locating Hinge-To-Door Bolts
  Courtesy of FORD MOTOR CO.
Remove the door.
To install, reverse the removal procedure.