Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the window control switch. For additional information, refer to WINDOW CONTROL SWITCH .
Remove the door trim panel and watershield. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Loosen the glass clamp screws.
- Temporarily install the window switch and lower the window to access the glass clamp screws.
- To install, tighten to 11 Nm (97 lb-in).
Remove the inner and outer belt line weatherstrips.

Fig 1: Removing Inner And Outer Belt Line Weatherstrips
Courtesy of FORD MOTOR CO.
Remove the glass run bolt.
- To install, tighten to 11 Nm (97 lb-in).
  
  Fig 2: Locating Glass Run Bolt
  Courtesy of FORD MOTOR CO.
Remove the rear door window glass from the regulator channel by sliding the channel rearward, then position the rear door window glass in the bottom of the door.
Remove the window glass.
- Remove the front edge of the window glass from the glass run.
- Lift the window glass up through the belt line weatherstrip opening to remove from the door.
To install, reverse the removal procedure.