LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 402 (Parking Aid System) >> Removal And Installation >> Parking Aid Sensor >> Removal

Parking Aid Sensor: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the electrical connector.
  3. Press the retaining tabs to remove the parking aid sensor(s).
    • Remove the parking aid sensor(s) from the rear bumper.
  4. To install, reverse the removal procedure.
  5. After installing the sensor(s), use the scan tool to verify that the parking aid sensor PIDs read no object present, 255 cm (100 in or 8.4 ft) and that the parking aid sensor attenuation PIDs read between 0-16 micro-seconds. If the parking aid sensor does not respond correctly, refer to PARKING AID  in the Diagnosis and Testing portion of this article.
scientia non olet · About LEMON Manuals