LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 400 (Information System And Entertainment System - SONY 8 Inch Touchscreen) >> Removal And Installation >> Antenna Cable - AM/FM >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Disconnect the antenna cable electrical connector.
  3. Remove the Audio Front Control Module (ACM). For additional information, refer to AUDIO CONTROL MODULE (ACM) .
  4. NOTE: Lower the glove compartment completely to access the retaining pins.

    Remove the antenna cable.

    • Release the retaining pins.
  5. To install, reverse the removal procedure.