LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 389 (Exterior Trim & Ornamentation) >> Removal And Installation >> Fender Moulding - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Left side shown, right side similar.
NOTE: Fender-moulding is one-time-use only.
  1. Remove the 5 rear fender wheel moulding retainers.
  2. NOTE: Before installing the new rear fender wheel moulding, clean the rear fender wheel moulding mounting area with an appropriate cleaner.

    Make sure all the old pressure sensitive tape is removed from the rear fender moulding mounting area.

  3. NOTE: After installation apply 7-11 kg (15-25 lbf) of pressure with a roller along the entire perimeter, including the bottom underwrap normal to the surface.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals