Transmission Support Crossmember: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All Vehicles

If required, install new transmission support insulator studs.
- Tighten to 75 Nm (55 lb-ft).
Position the transmission support crossmember and loosely install the LH bolt plate and new nuts.

Fig 1: Locating LH Transmission Support Crossmember Nuts
Courtesy of FORD MOTOR CO.
Loosely install the RH transmission support crossmember and gusset bolt plates and new nuts.

Fig 2: Locating RH Transmission Support Crossmember Nuts
Courtesy of FORD MOTOR CO.
Loosely install new transmission insulator nuts.

Fig 3: Locating Transmission Insulator Nuts
Courtesy of FORD MOTOR CO.
Tighten the transmission support crossmember-to-frame nuts to 110 Nm (81 lb-ft).
Remove the transmission jack.
TorqShift®6 Transmission
Install the 3 wiring harness retainers.
All Vehicles
Tighten the transmission insulator nuts to 115 Nm (85 lb-ft).