Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Remove the condenser core. For additional information, refer to CONDENSER CORE - 6.2L AND 6.8L or CONDENSER CORE - 6.7L DIESEL .
Unscrew and remove the plastic receiver/drier cap.
Remove the receiver/drier plug.
1. Push the receiver/drier plug upwards and remove the snap ring.
2. Install an M5 bolt in the center of the receiver drier plug and remove the plug.
  
  Fig 1: Identifying M5 Bolt Of Receiver/Drier Plug
  Courtesy of FORD MOTOR CO.
Using a suitable tool, grasp the receiver/drier cartridge grab handle and remove the receiver/drier cartridge.

Fig 2: Locating Receiver/Drier Cartridge
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Lubricate the receiver/drier plug O-ring seals using residual refrigerant oil from inside the receiver/drier.