Front Brake Pads: Installation
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new retracting clips and the 2 brake pads.
- If installing new brake pads, using a suitable tool and a worn brake pad, compress the disc brake caliper pistons into the caliper.
- Position the brake caliper and install the 2 bolts.
- On F250, F350, tighten to 76 Nm (56 lb-ft).
- On F450, F550, tighten to 63 Nm (46 lb-ft).
- Install the wheel and tire. For additional information, refer to WHEELS AND TIRES .
- Fill the brake master cylinder reservoir with clean brake fluid.
- Apply brakes several times to verify correct brake operation.
NOTE:
Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material. Do not install contaminated pads or damage to components may occur.
NOTE:
If installing new brake pads, install all new hardware as supplied with the brake pad kit.
NOTE:
Protect the piston and boots when pushing the caliper piston into the caliper piston bores or damage to components may occur.
NOTE:
Tighten the bottom caliper bolt before tightening the top caliper bolt or damage to guide pins may occur.
NOTE:
Make sure the caliper pin boots are correctly seated to prevent damage to the guide pins.