LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 377 (Automatic Transmission External Controls) >> Removal And Installation >> Brake Shift Interlock Actuator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the selector lever mechanism. For additional information, refer to SELECTOR LEVER MECHANISM .
  2. Remove the Brake Shift Interlock Actuator (BSIA) screw.
    G08341225
  3. Remove the BSIA.
    1. Gently pry out the clip.
    2. While simultaneously removing the BSIA from the selector lever mechanism housing.
      G08341226
  4. Remove the park position switch.
    1. Using a suitable tool, press the spring loaded pin.
    2. While rotating the park position switch clockwise and removing it from the selector lever mechanism.
      Fig 1: Pressing Spring Loaded Pin
      G08341227Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals