LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Electronic Engine Controls (Diesel)) >> Removal And Installation >> Engine Coolant Temperature (ECT) Sensor - Primary Cooling System >> Installation

Engine Coolant Temperature (ECT) Sensor - Primary Cooling System: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ECT sensor.
    • Tighten to 27 Nm (20 lb-ft).
  2. Connect the ECT sensor electrical connector.
  3. NOTE: Evaluate the cooling system condition before filling the engine cooling system. Failure to follow these instructions can result in damage to the engine.

    Evaluate the cooling system condition. For additional information, refer to Cooling System Condition Evaluation in ENGINE COOLING - DIESEL ENGINES .

scientia non olet · About LEMON Manuals