LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 370 (Electronic Engine Controls (Gas/Ethanol)) >> Removal And Installation >> Throttle Position (TP) Sensor - 6.8L (3V) >> Installation

Throttle Position (TP) Sensor - 6.8L (3V): Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the ETB.
    NOTE: Do not use power tools.

    Install the new TP sensor.

    • Using hand tools, install the 2 new bolts.
      • Tighten to 3 Nm (27 lb-in) .
    Fig 1: Locating TP Sensor
    G06139945Courtesy of FORD MOTOR CO.
  2. Connect the TP sensor electrical connector.
    Fig 2: Locating Throttle Position (TP) Sensor Electrical Connector
    G06139943Courtesy of FORD MOTOR CO.
  3. Install the ACL outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
scientia non olet · About LEMON Manuals