LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 370 (Electronic Engine Controls (Gas/Ethanol)) >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Mass Air Flow (MAF) sensor electrical connector.
  2. Remove the 2 bolts and the MAF sensor.
    • To install, tighten to 2 Nm (18 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals