Crankshaft Position (CKP) Sensor

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The accessory drive belt must be removed to perform this procedure. For additional information, refer to ACCESSORY DRIVE .

NOTE: The A/C compressor must be positioned aside to access the Crankshaft Position (CKP) sensor, it is not necessary to remove the A/C compressor from the vehicle.

NOTE: Lubricate the CKP sensor O-ring seal with clean engine oil prior to installation.

NOTE: After installing the CKP sensor, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

Fig 1: Crankshaft Position (CKP) Sensor Replacement Components With Torque Specifications -- 6.8L

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	N806184	A/C compressor bolt (3 required)
2	19703	A/C compressor
3	-	Crankshaft Position (CKP) sensor electrical connector (part of 12C508)
4	N806155	CKP sensor bolt
5	6C315	CKP sensor