LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 367 (Accessory Drive Belt) >> Removal And Installation >> Cooling Fan Drive Assembly - 6.7L Diesel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cooling fan. For additional information, refer to ENGINE COOLING - DIESEL ENGINES .
  2. Rotate the accessory belt tensioner clockwise and remove the accessory drive belt.
  3. Remove the 3 bolts and the cooling fan drive assembly.
    • To install, tighten to 24 Nm (18 lb-ft).
  4. NOTE: For additional information, refer to ACCESSORY DRIVE  in the Description and Operation portion for correct drive belt routing.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals