LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Engine Cooling System (Gas)) >> Removal And Installation >> Coolant Pump - 6.8L >> Coolant Pump >> Removal

Coolant Pump: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the cooling fan. For additional information, refer to COOLING FAN - 6.8L .
  3. Loosen the 4 coolant pump pulley bolts.
  4. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  5. Remove the 4 bolts and the coolant pump pulley.
  6. Remove the 4 bolts and the coolant pump. Discard the O-ring seal.
  7. Inspect the sealing surfaces and clean with metal surface prep. Follow the directions on the packaging.
scientia non olet · About LEMON Manuals