LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 363 (Instrument Panel And Console) >> Removal And Installation >> Console - Floor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 lower rear console bolts.
    • Position the passengers side inboard seat track cover aside to access the bolt.
    • To install, tighten to 70 Nm (52 lb-ft).
  2. Remove the bolt covers and the lower 2 center console bolts.
    • To install, tighten to 4 Nm (35 lb-In).
  3. Remove the bolt covers and the lower 2 front console bolts.
    • To install, tighten to 4 Nm (35 lb-In).
  4. Open the console lid and remove the storage trays.
  5. Using a suitable tool, pry up from the rear and remove the console finish panel.
  6. Remove the 2 upper console bolts.
    • To install, tighten to 3 Nm (27 lb-In).
  7. Disconnect the electrical connector from the right side of the floor console and remove the floor console.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals