LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Front Door Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: The window must be in the raised position.

    Remove the exterior front door handle. For additional information, refer to EXTERIOR FRONT DOOR HANDLE .

  2. Disconnect the push button rod from the front door latch.
  3. Release the front door latch actuating cable locators.
    Fig 1: Locating Front Door Latch Actuating Cable Locators
    G07975552Courtesy of FORD MOTOR CO.
  4. Remove the 3 screws and position the front door latch aside.
    • To install, tighten to 12 Nm (106 lb-in).
  5. Disconnect the front door latch electrical connector(s).
  6. Remove the front door latch cable water seal.
  7. Remove the front door latch.
    • Release the cable conduit.
    • Release the cable.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals