LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Door Latch Remote Control - SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear speaker. Refer to the appropriate Information and Entertainment Systems article for the procedure.
  2. Position the water shield aside.
  3. Remove the 3 upper rear door latch screws.
    • To install, tighten to 12 Nm (106 lb-in).
  4. Remove the 3 lower rear door latch screws.
    • To install, tighten to 12 Nm (106 lb-in).
  5. NOTE: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal. Make sure not to exceed a 6.35 mm (0.25 in) drill bit.

    Remove the rear door latch remote control.

    1. Disconnect the actuating rods.
    2. Remove the rivets.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals