Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The window must be in the raised position.

Remove the exterior door handle. For additional information, refer to EXTERIOR REAR DOOR HANDLE - CREW CAB .
Release the lock linkage guide clip from the rear door.

Fig 1: Locating Rear Door Lock Linkage Guide Clip
Courtesy of FORD MOTOR CO.
Release the clip and disconnect the door lock actuating rod from the latch.
Release the clip.

Fig 2: Locating Door Lock Actuating Rod Clip
Courtesy of FORD MOTOR CO.
Remove the 3 screws and position the rear door latch aside.
- To install, tighten to 12 Nm (106 lb-in).
Remove the rear door latch actuating cable water seal.

Fig 3: Locating Rear Door Latch Actuating Cable Water Seal
Courtesy of FORD MOTOR CO.
Disconnect the actuating cable and conduit.
Disconnect the 2 electrical connectors and remove the rear door latch.
To install, reverse the removal procedure.